SOP FOR FRONT FORK DUST SEAL & OIL SEAL REPLACEMENT
• Remove speed sensor assembly & Take out front wheel assembly.
• Remove 4 no. bolts (2 nos.
on both LH & RH side)
securing front fender by
12mm ring spanner & take
out front fender assembly.
• Remove allen bolt of upper
bracket by 6mm allen key &
under bracket bolt by 17
mm ring spanner.
• Take out the front fork leg assembly.
• Remove fork top bolt by 14mm Allen key.
Pulsar 150/180 DTS-i
Service Station Manual
171
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
