Bajaj pulsar DTS-i - Page 176

SOP FOR FRONT FORK DUST SEAL & OIL SEAL REPLACEMENT
• Remove spacer tube, washer & Front fork spring.
• Remove front fork oil & collect in measuring jar.
• Hold piston with cylinder piston holder special tool & remove Allen bolt
by 6mm allen key
• Remove dust seal & oil seal lock (snap ring).
• Insert the front fork anti-friction bush & oil seal extraction special tool on
fork inner pipe as per sequence shown in photograph.
Pulsar 150/180 DTS-i
Service Station Manual
172
Dealer Development Center
Akurdi Pune
Ap[Sr Ty&b, vi[Sr an[ f\ºT f\[m l[g Ap\)>gn[ bhir kiQi[.
aigLni fi[k<ni ai[el bhir kiQ) m[zr)>g Ôrmi> niKi[.
s)l)ºDr p)ATn hi[ÃDr Ap[Syl T&Ãs oiri p)ATnn[ hi[ÃD kr)
Ki[li[.
6mm
Allenkey
oiri
DAT s)l an[ ai[el s)l li[kn[ bhir kiQi[. {An[pr)>g}
f\ºT fi[k< a[ºT) (fkSn b&S an[ ai[el s)l p&lrn[ enr piep upr fi[Ti[g\ifs
p\miN[ m&ki[.
SOP DAT s)l ai[el s)l bdlvin) p¹Ft)