SOP FOR FRONT FORK DUST SEAL & OIL SEAL REPLACEMENT
• Remove handle bar holder by removing 2 nos allen bolts with 6mm allen
key.
• Insert fork inner pipe along with special tool in under bracket such that
special tool top portion touches to under bracket bottom edge.
• Tighten the fork upper bracket allen bolt by 6mm allen key.
• Remove outer tube by rotating special tool in clock wise direction
• Remove fork inner pipe from under bracket & take out the special tool as
shown in photograph.
Pulsar 150/180 DTS-i
Service Station Manual
173
Dealer Development Center
Akurdi Pune
h[ºDl bir hi[ÃDrni b[ bi[ÃTn[ 6 Wiri Ki[li[.fimm Allen Key
fi[k< apr b\[k[Tn[ 6 bi[ÃT n[ TieT kri[.
mm Allen key
Ap[Syl T&Ãsn[ kli[k viez (dSimi> f[rv) aiuTr Ty&bn[ bhir kiQi[.
aºDr b\[kTmi>Y) fi[k< enr piepn[ fi[Ti[g\ifsmi jNiv[l p\miN[ bhir kiQi[.
To Next Page
Loading...
