Bajaj pulsar DTS-i - Page 178

SOP FOR FRONT FORK DUST SEAL & OIL SEAL REPLACEMENT
• Take out front fork oil seal, washer & anti-friction bush.
• Hold fork cylinder on cylinder piston holder tool & insert spring and fork
inner pipe.
• Assemble oil lock cap & outer tube followed by tightening of allen bolt
(From bottom side of outer tube) by 6mm allen key.
• Hold fork leg assembly & assemble anti friction bush, washer & oil seal
as shown in photographs.
Assembling
Pulsar 150/180 DTS-i
Service Station Manual
174
Dealer Development Center
Akurdi Pune
f\ºT fi[k< ai[el s)l/vi[Sr an[ a[ºT) f)kSn b&Sn[ bhir kiQi[.
f)T krv&
s)l)ºDr p)ATn hi[Ã|Dr T&l upr fi[k< s)l)ºDr n[ hi[ÃD kr) a>dr Ap\)>g an[
enr piep f)T kri[.
ai[el ki[l k[p an[ aiuTr Ty&b Ryirbid 6 bi[ÃT Wiri
TieT kri. {aiuTr Ty&b n) n)c[n) trfY)}
mm Allen key
fi[k< l[g a[s[Àbl)n[ pkD)n[ a[ºT) f)kSn b&S/vi[Sr/an[ ai[el s)l f)T
kri[. fi[Ti[g\ifs p\miN[