Bajaj pulsar DTS-i - Page 197

SOP FOR SWING ARM REPLACEMENT
• From RH side of frame’s steering tube area route the corrugated
wiring harness as shown in the photograph.
• Clamp the wiring harness at the lamp shade clamp & frame’s RH
side clip as shown in the photograph.
• From LH side of frame’s steering tube area route the corrugated
wiring harness as shown in the photograph.
• Clamp the wiring harness at the lamp shade clamp for both side
wiring harness respectively as shown in the photograph.
Pulsar 150/180 DTS-i
Service Station Manual
193
Dealer Development Center
Akurdi Pune
SOP Av)>g aim< bdlvi miT[
RH sieD f\[m AT)ar)>g Ty&b bij&Y) b[r)>g hirn[sn[ $T kri[ {fiTi[giifs p\miN[}
viyr)>g hirn[s n[ kl[Àp, l[Àp ri[Dni kl[Àp j[ f\[m upr sieD upr aip[l
C[ t[ p\miN[ kri[ {fi[Ti[g\ifs p\miN[}
RH
f\[mn) sieD kupr AT)ar)g Ty&b sieD upr AT)ar)>g Ty&b viyr)>g
hirn[s $T)>g kri[. fi[Ti[g\ifs p\miN
LH
l[Àp S[D upr viyr)>g hirn[sn[ kl[Àp kri[.{fi[Ti[g\ifs p\miN[}