Bajaj pulsar DTS-i - Page 198

SOP FOR SWING ARM REPLACEMENT
• Clamp the wiring harness on main member of frame by band as
shown.
• Clamp the wiring harness on main member of frame (above the
battery) by band as shown.
• Clamp the wiring harness on LH side long member of frame at
two locations shown.
• Clamp the fuse box as shown in photograph.
Pulsar 150/180 DTS-i
Service Station Manual
194
Dealer Development Center
Akurdi Pune
SOP Av)>g aim< bdlvi miT[
m[en m[Àbr upr {f\[m upr} viyr)>g hirn[sn[ kl[Àp kri[.
f\[mni m[en m[Àbr upr viyr)>g hirn[s kl[Àp kri[. {b[Tr) upr}
viyr)>g hirn[sn[ sieD f\[mni li[ºg m[Àbr upr b[ j³yia[ kl[Àp kri[.LH
fy&z bi[ksn[ fi[Ti[g\ifsmi btiv[l p\miN[ kl[Àp kri[.