Bajaj pulsar DTS-i - Page 201

SOP FOR CALIPER PISTON SEAL AND DUST SEAL REPLACEMENT
• Clean master cylinder & caliper thoroughly by low pressure water spray
before opening master cylinder top cover & caliper bleeder screw.
• Drain the brake fluid from caliper assembly by loosening air bleeder
screw & using transparent PVC tube which will avoid spillage of brake
fluid on caliper body / disc pads & also powder coating peel off /
inefficient braking.
• First remove hose pipe by removing banjo bolt & then remove caliper
assembly from fork mounting location.
• Remove the allen bolt of LH caliper.
• Remove both brake pads.
Pulsar 150/180 DTS-i
Service Station Manual
197
Dealer Development Center
Akurdi Pune
SOP k[l)pr p)ATn s)l an[ DAT s)l bdlvi miT[
miATr s)l)ºDr an[ k[l)prn[ kim krti ph[li li[ a[r p[\[srY) bribr sif
kr) Ryir bid j miATr s)l)ºDr Ti[p kvr an[ k[l)pr ¾l)Dr Ak\& Ki[lvi.
b\[k ai[el n[ k[l)pr a[s[Àbl)miY) piLi Wiri ¾l)Dr Ak\& Ki[l) bhir
kiQi[ j[Y) ai[el k[l)pr bi[D)/D)Ak vD[ upr ni pD[ an[ klr Krib ni Yiy
PVC
b[ºÔ[ bi[ÃTn[ Ki[l)n[ hi[s piep bhir kiQi[ Ryirbid k[l)pr a[s[Àbl)n[ fi[k<
uprY) Ki[li[.
LH Allenk[l)prni bi[ÃTn[ bhir kiQi[.
b>n[ b\[k p[>Dn[ bhir kiQi[.