Bajaj pulsar DTS-i - Page 202

SOP FOR CALIPER PISTON SEAL AND DUST SEAL REPLACEMENT
• Remove holder bracket & pad spring.
• Remove piston by applying compressed air through banjo bolt hole. Due
to compressed air pressure, the piston will be pushed out of caliper
body.
• Remove pistons & all rubber parts. Clean caliper body by Diesel /
Kerosene. Dry caliper body by applying compressed air.
Caution :
Do not apply high compressed air pressure >2 bar. This could
cause piston to fly out from caliper body, causing damage to it &
any one in the vicinity.
Pulsar 150/180 DTS-i
Service Station Manual
198
Dealer Development Center
Akurdi Pune
SOP- k[l)pr p)ATn s)l an[ DAT s)l bdlvi miT[
hi[ÃDr b\[k[T an[ p[s Ap\)>gn[ bhir kiQi[
b[ºÔ[ bi[ÃTmi hvini p\[srY) hvi mir) p)ATnn[ bhir kiQi[. hvini
p\[srn[ l)F[ p)ATn bhir aivri[.
c[tvN):
2 birY) vF& hie a[r ki[Àp\[s a[rY) t[n[ sif ni krv&> nh)tr p)ATn k[l)pr
bi[D)mi>Y) bhir n)kL) jS[ an[ ki[en[ n&ksin Yvin) Skyti rh[ C[.
p)ATn an[ bFi rbr piT<sn[ bhir kiQ) k[l)pr bi[D)n[ D)zl/k[ri[s)n Wiri
sif kri[ an[ k[l)pr bi[D)n[ hvi Wiri sif kri[.