SOP FOR BRAKE FLUID REPLACEMENT
• Perform air bleeding of disc brake system if the brake operation is
spongy.
a. Remove rubber cap from caliper's bleeder screw.
b. Fit a proper tube which fits snugly tight on the bleeder screw nipple.
c. Insert ring spanner through the pipe fitted on the bleeder screw nipple.
d. Connect the tube to siphon pump's pipe and loosen the bleeder screw
by the ring spanner.
e. Press the bellow of the Siphon pump in its valve open position. Then
close the valve of the pump and release the bellow. Simultaneously
press the brake lever to take out air trapped in the system. Carry out
the same procedure until the entire air trapped in the system gets
removed.
• Fill the master cylinder reservoir by using DOT-3 / DOT-4 brake fluid.
• Fill the master cylinder reservoir by using DOT-3 / DOT-4 brake fluid.
Pulsar 150/180 DTS-i
Service Station Manual
210
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
