BATTERY
LED Indication Status Result Action
Green LED glowing OK Battery is fully charged Battery can be used on the
vehicle.
Green & Yellow LED OK / LOW Battery is partially discharged. Charge the battery on battery
glowing charger
Yellow LED glowing LOW Battery is discharged & needs charging Charge the battery on battery
charger
Red LED glowing Not OK Try charging on charger.
Observe for half an hour if
charger gives indication of ‘bad
battery’, then discontinue
charging and scrap the battery.
If there is no bad battery
indication then continue charging
till charging is over.
Again test battery condition
using PBT 50 load tester. If
result is OK, then put the
battery on vehicle.
7 •
•
•
•
For checking condition of battery, load tester as per
following specifications is to be used :
Make Midtronics
Model PBT50
Procedure for checking battery condition
Disconnect battery +ve & -ve terminals.
Confirm battery type & reference no.
Connect load tester's Red & Black cable to battery +ve & -ve terminal respectively.
Press test button.
•
•
•
•
Checking Condition of Battery
Pulsar 150/180 DTS-i
Service Station Manual
217
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
