Switches :
Front Brake Light Switch Inspection :
• Turn ON the ignition switch.
• The brake Light LED Blank should get on when the front
brake (Lever is pressed) is applied.
• If it does not, check the Front brake switch.
Lever Pressed
Lever Released
Brown Blue
Rear Brake Light Switch Timing Inspection :
• Turn ON the ignition switch.
• Check the operation of the rear brake light switch by
depressing the brake pedal
• If it does not operate as specified, adjust the brake light
switch or check the switch.
Pedal Pressed
Pedal Released
Brown Blue
Ignition Switch :
‘OFF’
‘ON’
Brown/Blue White
Neutral Switch :
• The neutral switch will be in ON position only when the
engine is in neutral.
• The neutral light will not glow when vehicle is in gear.
‘ON’ (Vehicle in neutral)
‘OFF’ (Vehicle in gear)
Light Green Earthing
ELECTRICAL CHECKING
PROCEDURES
Pulsar 150/180 DTS-i
Service Station Manual
218
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
