ELECTRICAL CHECKING
PROCEDURES
Tail LED Lamp :
The illumination for Tail lamp and Brake lamp are done through 2
rows of LED’s each. These are high intensity LED’s.
The main advantage of these LED’s is that;
• They consume very less power. i.e LED consumes 3W
power against 21 W power of a conventional brake lamp.
• Life of LED is infinite.
• Light output is equivalent to that of a bulb.
• With this tail LED lamp battery discharge possibility is very
minimum in case of a brake switch short condition.
When you operate light control switch to glow, the intensity is low. As
soon as you operate brake switch the brightness of LED increases to
show you bright light.
This changeover of intensity is maintained with the help of electronic
circuit placed inside Tail Lamp Console assly and is a totally sealed
unit.
Pulsar 150/180 DTS-i
Service Station Manual
225
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
