Bajaj pulsar DTS-i - Page 231

ELECTRICAL CHECKING
PROCEDURES
Location : Mounted on bracket above high beam projector lamp.
This unit is a combination of head light controller & flasher unit.
Function :
The flasher circuit controls the flashing rate & operation of side indicators.
The light control module switches ON head light (Low beam & High beam)
only when engine is in running condition.
Light Control Module
Light Control Module
4 pin coupler
2 pin
coupler
YBr
Or B/Y
Br Violet
Light Control
Module
Y
Br
Or
B/Y
Br
Violet
I/P from magneto
Earthing
Flasher circuit
Flasher circuit
12VDC from battery
I/P to H/L switch
Measuring & Testing Equipment : Multimeter.
SOP :
• Switch ON ignition switch & kill switch.
• Set multimeter to 20 VDC.
• Connect multimeter as shown in table given below.
Ignition switch ON & kill switch
ON.
Sr.
Condition
1.
2.
Wire connections Std Reading
Meter +ve Meter -ve
Br (2 pin
coupler)
B/Y 12 VDC
Engine is running - H/L switch
OFF.
Engine is running - H/L switch
ON.
Violet
Violet
B/Y
B/Y
14.5 VDC
13.5 VDC
3.
Pulsar 150/180 DTS-i
Service Station Manual
227
Dealer Development Center
Akurdi Pune