Bajaj pulsar DTS-i - Page 238

SOP FOR CHECKING CHARGE CONDITION OF BATTERY
• Ensure Ignition switch of the vehicle is in OFF position.
• Disconnect battery terminals. Always remove negative wire
first, then remove positive wire
• Confirm battery type,& check for reference no. printed on the back side of
the instrument
Connect Battery tester clamps to battery terminals, observing correct
polarities.
• Connect + ve & - ve wire clamps of Battery to +ve & -ve terminals of the
Battery tester.
SOP for Checking Charge Condition of Battery
Pulsar 150/180 DTS-i
Service Station Manual
234
Dealer Development Center
Akurdi Pune
vihnn) e³n)Sn Av)c pi[z)Snmi> l[v) j$r) C['OFF'
b[Tr) Tm)<nlni kn[kSnn[ Ki[li[. hm[Si - viyr ph[li Ki[li[ Ryirbid +
viyrn[ Ki[lci
ve ve
c[k b[Tr) an[ r[frºs n>br j[ piCLn) Big upr aip[l C[
b[Tr) T[ATni kl[Àpn[ kn[kT kr) pi[l)s) bribr C[ k[ nh) t[ c[k kri[ +
an[ - viyr n[ b[Tr) T[ATr siY[ kn[kT kri[
ve
ve
SOP
- b[Tr)n) cij< k>D)Sn c[k)>g
SOP - b[Tr)n) cij< k>D)Sn c[k)>g