• Confirm display indication on LCD.
• Clamps connection is not firm, remove dirt, dust, rust if any from battery
terminals.
• Battery voltage is less than 8VDC.
• Internal disconnection of battery terminal
• This is reference no. typed when used last time. Set correct reference no.
of battery to be tested using UP/DOWN keys & reference no. chart printed
on back side of the instrument.
• Push “TEST” button for checking condition of battery tester
• Voltage indication & Green LED is glowing-Battery is OK & can be used
on vehicle.
Pulsar 150/180 DTS-i
Service Station Manual
235
Dealer Development Center
Akurdi Pune
SOP FOR CHECKING CHARGE CONDITION OF BATTERY
LCD D)A¼l[ cil& C[ k[ nh) t[ c[k kri[
b[Tr) Tm)<nln[ sif kr) kn[kSn n kri[
8 krti vi[ÃT[j ai[Ci hi[yvdc
b[Tr)ni eºTrnl kn[kSnn[ c[k kri[
ai agiuni r[frnsmi jyir[ vipr[l t[ p\miN[ b[Tr) T[ATr T[AT krvi
k) vipri[ an[ r[frºs miT[ piCL ciT< aip[lC[up/down
b[Tr) T[ATr ni p&S bTnn[ dbivi[
Ô[ b[Tr) T[ATr upr g)\n lieT btiv[ ti[ b[Tr) C[ok
To Next Page
Loading...
