DOS AND DON’TS
LIGHTS
•
•
•
•
Check that all bulbs are firmly fitted in bulb holder.
Ensure that all fixing screw of bulb housing are intact.
Ensure that Reflector / Glass of Head Lamp, Tail Lamp, Side
indicator is intact.
Check that couplers and wires of bulbs are in good condition.
• Do not install a lower / higher capacity battery than what is
recommended.
• Do not use Higher / Lower wattage Bulbs.
• While washing Vehicle do not direct pressurized water jet on Head
Light, Tail Light,Indicators.
• Do not ride on brakes.
• Do not start Vehicle with light control switch in ON condition.
Dos
3
Don'ts
7
SWITCHES
•
•
•
After washing the vehicle ensure to apply dry air on switches before
operation.
Always ensure that grommets provided on clutch switch, front brake
switch and rear brake switch are intact.
Always apply WD-40 Rust Spray to sticky switches.
•
•
•
•
•
•
Do not apply direct pressurized water jet on control switches.
Do not lubricate electrical switches by oil or grease.
Do not over tighten the switches.
During warranty period do not dismantle control switches.
Do not add extra electrical loads e.g. musical horns, additional horns,
buzzers as it will reduce switch contact life & battery life &battery life.
Do not operate switch immediately after water servicing.
Dos
3
Don'ts
7
Pulsar 150/180 DTS-i
Service Station Manual
239
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
