WORKSHOP SAFETY
Pulsar 150/180 DTS-i
Service Station Manual
4
Dealer Development Center
Akurdi Pune
o Technicians must put on shoes & dressing should not be very loose.
o Technicians must use Personnel Protective Equipment (PPE) like - Hand
Gloves
- Mask
- Safety Goggle
- Ear Plug
o Wear Nitrile Rubber Hand Gloves while handling petrochemicals like
petrol, Oil, Kerosene etc.
o Precautions to be taken while handling MRTB Test
- Take care that the vehicle is properly clamped in the clamping device,
otherwise it may go back with a force and can injure the rider.
- Keep yourself cool while taking tests. It is very necessary to be alert.
- Mount the vehicle in the center of the rollers.
- Fuel pipe should not touch heated part of the vehicle, it may cause
fire.
- Make sure to put on air blower while conducting test to avoid engine
overheating.
- Lock the front wheel properly
- Ensure that exhaust blower is running.
- Wear Helmet
- Wear ear plugs
o Precautions to be taken while handling CO Gas Analyser
- Use hand gloves for protection from hot silencer.
- Use mask for protection from exhaust gases.
- Ensure proper ventilation.
o Fire Extinguisher
- Install ‘ISI’ approved. Fire extinguishers - CO gas cylinders.
- Refill CO before the gas expires.
- Install Co gas cylinder at appropriate place so that there is no
obstruction / good accessability.
2
2
2
To Next Page
Loading...
