o Hand Tools
- Do not use worn out hand tools.
o Calibration of Workshop Equipment
- Calibrate all Workshop and M & T Equipment once in a year.
o Avoid direct body contact with Petrol, Kerosene.
Caution : Prolonged contact of used oil may cause cancer.
o Waste Oil Disposal
- Sell used oil to Government approved re-cycle agencies.
- Collect used oil in oil disposer / barrel.
- Don’t throw oil into sewage line.
- Don’t spill oil on the floor.
o Safety Precautions while Operating Air Tools
Air tools operate on compressed air supplied by the shop air system
(Compressor & Air supply system).
Observe the following safety related precautions when using an air tool.
• It is advisable to fit a pressure regulator (FRL:- Filter Regulator
Lubricator) in the pneumatic line which supplies air pressure to the air
tool. It regulates the outlet pressure to @6.5 Kg/cm . This avoids the
risk of personal injury.
• Never use the blow gun to blow dust off your clothes and never point
it at anyone. The air pressure can drive dust particles at high speed.
These particles can penetrate into the flesh or eyes. High pressure air
hitting on open wound can force air into the blood stream. This can
result in death.
• Never look into the air outlet of a pneumatic tool.
• Never blow-clean brake or clutch parts. This could put asbestos dust
particles into the air which are harmful to inhale. (These particles are
cancerous - can lead to Cancer).
2
WORKSHOP SAFETY
Pulsar 150/180 DTS-i
Service Station Manual
5
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
Need help?
General
