WORKSHOP SAFETY
Service Support - M/C
Service Station Manual
• Technicians must put on shoes & dressing should not be very loose.
• Technicians must use Personnel Protective Equipment (PPE) like –
- Hand Gloves
- Mask
- Safety Goggle
- Ear Plug
• Wear Nitrile Rubber Hand Gloves while handling
petrochemicals like petrol, Oil, Kerosene etc.
2
Precautions to be taken while handling Fire Extinguisher
- Install ‘ISI’ approved Fire extinguishers – CO2 gas cylinders.
- Refill CO2 before the gas expires.
- Install CO2 gas cylinder at appropriate place so that there is
no obstruction / good accessibility.
Safety Precautions while Operating Air Tools
Air tools operate on compressed air supplied by the shop air system
(Compressor & Air supply system).
Observe the following safety related precautions when using an air tool.
• It is advisable to fit a pressure regulator (FRL:- Filter Regulator Lubricator)
in the pneumatic line which supplies air pressure to the air tool.
It regulates the outlet pressure to @6.5 Kg/cm². This avoids the risk of personal injury.
To Next Page
Loading...
Need help?
General
