Service Support - M/C
Service Station Manual
3
• Never use the blow gun to blow dust off your clothes and never point it at anyone. The air
pressure can drive dust particles at high speed. These particles can penetrate the flesh or eyes.
High pressure air hitting on open wound can force air into the blood stream. This can result in death.
• Never look into the air outlet of a pneumatic tool.
• Never blow-clean brake or clutch parts. This could put asbestos dust particles into the air which
are harmful to inhale. (These particles are cancerous - can lead to Cancer).
• Hand Tools
- Do not use worn out hand tools.
• Calibration of Workshop Equipment
- Calibrate all Workshop and M & T Equipment once in a year.
• Avoid direct body contact with Petrol, Kerosene.
Caution : Prolonged contact of used oil may cause cancer.
• Waste Oil Disposal
- Sell used oil to Government approved re-cycle agencies.
- Collect used oil in oil disposer / barrel.
- Don’t throw oil into sewage line.
- Don’t spill oil on the floor.
WORKSHOP SAFETY
• Precautions to be taken while handling Hydro-Electric Lift
- While raising / lowering the lifter bay ensure that vehicle is
firmly hold on the lifter bay to avoid accident.
- After raising the lifter bay, lock the lift.
- Don’t put leg/hand in between while raising / lowering the lifter Bay.
• Safety Tips
- Do not lower the lifter bay table without unlocking the mechanical lift lock.
- Do not keep your leg between the top and bottom frame while lowering the lifter bay.
- Do not work with loose clothing while working on the lifter bay.
- Do not keep hydraulic joints loose.
- Do not stand on the lifter bay’s top, when it is being operated.
- Special care is to be adopted to avoid injuries if either leg or hand is entangled between.
- Keep off direct fire near the power pack.
- Avoid oil spillage around the working area for safety reasons.
• Electrical Wiring
- Carry out periodic checks & repairs
- Electrical board & Main Switch must be located such that they are easily accessible.
To Next Page
Loading...
Need help?
General
