I、Warning :please read the following instructions before operation, which is a safety guaranty to
SPA users.
、
、
、
、
、
、
、
、：
、
、
、
、
、
、
、
、
、
、
、
、
、
、
、
、
、
26、The product must be permanently connected to the fixed wiring.
27、Parts incorporating electrical components must be located or fixed so that they cannot fall into the bath.
28、The product should be supplied through a residual current device (RCD) having a rated residual operated
current not exceeding 30mA.
29、If your SPA is placed in direct sunlight , as possible as you can, please avoid to place it on the glass floor or near
the location of the glass wall , specular reflection effects can lead too high temperature on partial skirt which
will cause skirt deformation.
30. The bearing of the water pumps may get stuck after this SPA hasn’t been used for a long time, so the water
pumps may not working when pressing the water-pump buttons on control panel. If the water pump not
working because of water bearing get stuck, then you can notice that no water current through jets or no
suction- force in the skimmer. Please shut down the power ,open the hem doors, find out the water pumps,
rotate the blade inside water pumps, turn on the power again, activate the water pumps by pressing the water-
pump buttons several times.
31. Sometimes, the water pumps may work or rotate slowly at the beginning and back to normal after working 2-3
seconds. If the water pumps still rotate slowly after 2-3 seconds, please press the water-pump buttons on panel
to re-activate the pumps.
32. When you notice the hum of the water pumps while pumps not working (no water current through jets) and
overheating water pump surface, please shut down power immediately. It results from air kept inside of water
pumps or pipes be block. Please check the water pumps and pipes, fix the problem , and turn on the power
again.
33. During installation of the SPA, please keep the whole construction area clean and clear .No mud or metal be
left beneath the SPA tub body or near the water pumps. Keep sufficient space for dissipating heat of the
working water pumps.
To Next Page
Loading...
