Balflex P20 - Mounting Instructions

P20 / P32 OPERATIONS MANUAL
Page | 3
Size and Weight of package:
Specification
Length (X)
Width (Y)
Height (Z)
Gross Weight
Net Weight
mm
mm
mm
Kg
kg
P20
Machine
760
600
810
190
155
Die Rack
660
340
800
P32
Machine
760
600
810
280
225
Die Rack
660
340
800
MOUNTING
The above picture shows an appropriate way to lift the machine after it has been unpacked. It is recommended to
mount the machine on a BALFLEX rack. Before mounting, the rack must be screwed on the floor with four M12 wedge
anchors. Boreholes in the floor: 12mm, depth 55 mm. When the machine is mounted on a BALFLEX rack, the four
shoes under the machine are removed. The table with assembly instructions is packed separately. The crimper may
be installed on some other table as well, provided it is sturdy and broad enough or it has been fastened on the floor
so that it cannot fall over. Furthermore, there must be a hole in the table to enable emptying the oil tank through the
drain plug.