Balflex P32 - User Manual

Questions and Answers

R
Robert SchneiderAug 10, 2025
What to do if my Balflex Industrial Equipment machine will not start?
- R
  ronald06Aug 10, 2025
  If your Balflex Industrial Equipment machine won't start, there are several potential causes: 1. **No electric supply:** Check the fuses and supply cable connections. 2. **Motor protection tripped:** Reset the motor. If it trips again, inspect the motor and pump condition. 3. **Switch broken:** Check the voltage up to the motor. 4. **Low supply voltage:** Verify the voltage.
B
Brittany WilsonAug 17, 2025
Why is there insufficient crimping force in my Balflex P32?
- G
  gonzalezwesleyAug 17, 2025
  If the crimping force of your Balflex Industrial Equipment is insufficient, consider these possible reasons: 1. **Insufficient lubrication:** Lubricate the dies. 2. **Low oil level:** Check and refill the oil. 3. **Pressure relief valve stuck:** Check and clean the valve. 4. **Pilot check valve leaking:** Replace the valve if it's broken. 5. **Leaking pump/pressure pipe:** Check, tighten, or replace the pump/pipe. 6. **Coupling between motor and pump slipping:** Check and replace the coupling.
F
feliciaherreraAug 25, 2025
What to do if the motor runs but there is no piston movement in my Balflex P32?
- M
  Michael RayAug 26, 2025
  If the motor runs but there is no piston movement in your Balflex Industrial Equipment, consider the following: 1. **Wrong rotation direction:** Interchange two phases in the supply disconnecting device. 2. **Low oil level:** Check and refill the oil. 3. **Fuses/rectifier/transformer out of order:** Check and replace them as needed. 4. **Dial broken (MS):** Check and replace the dial. 5. **Valve out of order:** Check the movability of the valve steam. 6. **Pump or coupling broken:** Check the solenoids and replace the pump or coupling if necessary.
H
harrisashleeSep 2, 2025
How to troubleshoot crimping diameter variations in Balflex Industrial Equipment?
- R
  Robert ChanSep 2, 2025
  If the crimping diameter varies when using your Balflex Industrial Equipment, here are some potential causes: 1. **Insufficient lubrication:** Lubricate the dies. 2. **Set value changed:** Check the set value. 3. **Dial knob loose (MS):** Check, calibrate, and tighten the dial knob. 4. **Dial loose or broken (MS):** Check, tighten, or replace the dial. 5. **Valve sticking:** Check and clean the valve.