Page 8 MODEL 205 ce
SECTION 6 - TROUBLESHOOTING
The following is a list of troubleshooting
questions:
Are the pickup and cable in good condition and
connected properly?
Is the power ON? Is the battery good?
Is the display on?
Are the switches inoperative, or experiencing
other switching problems?
TROUBLESHOOTING GUIDE
Symptom: No Display
Possible
Cause: No power or supply voltage
Solution: [1] Check power source
(batteries). Replace if
necessary.
[2] Check power OFF/ON
switch.
Symptom: No Indication on Meter Display
Possible
Cause: No vibration signal
Solution: [1] Check vibration pickup and
cable.
[2] Possible defective pickup.
[3] Possible defective display.
Symptom: Amount Readings Unstable
Possible
Cause: [1] Machine defect
[2] Improper setup (low range)
Solution: [1] Check vibration pickup for
proper installation.
[2] Check for loose machine
components.
[3] Verify pickup and cable
connections.
[4] Signal to noise ratio is low
(low range in displacement).
Reduce noise, increase
Amplitude range, or change
Amplitude units.
SECTION 7 - SUPPORT
TECHNICAL SUPPORT - For additional
technical information, contact Balmac.
Additional information about vibration is available
in our Vibration Analysis Training Manual and
our “B” Book Series.
For information on vibration standards for ISO
and ANSI, contact Balmac or check the Internet.
All questions and problems should be directed
to the factory Monday through Friday, 8:00 A.M.
to 5:00 P.M. Eastern Time at the following
numbers:
Telephone: 614-873-8222
Email: sales@balmacinc.com
Ship To: BALMAC, INC.
8205 Estates Pkwy, Ste N
Plain City, OH 43064-8080
SERVICE SUPPORT - The instrument is
warranted for a period of two years. It is
recommended you contact Balmac before
returning equipment for service. Instrumentation
returned prepaid to Balmac during the warranty
period will be repaired or replaced without
charge if it has not been subjected to misuse.
Return freight is chargeable. Equipment
returned for service should be packed in a
suitable shipping container.
To Next Page
Loading...