operational check of controls and valves. Complete operational check of ALL safety devices (door
switch, lint drawer switch, sail switch, burner and high limit thermostats).
6.2.4 Lubrication
1. Impeller (fan/blower) shaft bearings should be lubricated every three (3) months. Use a
lithium complex based grease EP II or equivalent.
2. Lubricate idler bearings and tumbler bearings. Use a lithium complex based grease EP II or
equivalent.
6.3 Service & Parts
6.3.1 Service
Service must be performed by a qualified trained technician, service agency, or gas supplier. If
service is required, contact the distributor from whom the equipment was purchased. If the dis-
tributor cannot be contacted or is unknown, contact B&C Technologies for a distributor in your
area.
For technical assistance in the United States, contact B&C Technologies:
(850) 249-2222 Phone
(850) 249-2226 FAX
parts@bandctech.com
www.bandctech.com
NOTE: When contacting B&C Technologies be sure to supply the correct model number and serial
number so that your inquiry is handled in an expeditious manner.
6.3.2 Parts
Replacement parts should be purchased from the distributor from whom the equipment was pur-
chased. If the distributor cannot be contacted or is unknown, contact B&C Technologies for a
distributor in your area. Parts may also be purchased directly from the factory
NOTE: When ordering replacement parts from a dealer or B&C Technologies, be sure to supply
the correct model number and serial number so that your parts order can be processed in an expe-
ditious manner.
37
To Next Page
Loading...
General