Chapter 8
Appendix
8.1 Gas Conversion Technique
Follow the following procedure in order to convert a DE Series dryer from Natural Gas to LP or
vice versa:
8.1.1 Converting Gas Types, DE-30
Refer to figure 8.2 on page 41 for details.
IMPORTANT: When changing gas types, burner orifices/nozzles must also be changed.
Refer to table 8.1 on page 42 for correct part numbers.
1. Turn off gas and electricity to machine.
2. Remove slotted cap (A), adjusting screw (B), and spring(C).
3. Install new spring (LP Gas spring is pink).
4. Install new adjusting screw, supplied with kit.
5. Remove fitting (D) and attach manometer adapter and manometer.
6. Restore gas and electricity.
7. With burner on, adjust screw (B) so that the manometer reads the pressure as reccomended
on the serial decal.
8. Turn off gas and electricity to machine.
9. Remove manometer and replace fitting (D).
10. Install replacement cap (A), supplied with kit.
39
To Next Page
Loading...