ROTATIONAL CONTROL RESET FUNCTION
To reset the rotational controller to its factory setting begin by ensuring the controller is powered off. Place the jumper
for “Max Pumps” onto 1 pump, then power on. Simulate a call, then power off. Relocate the jumper onto the proper
number of pumps for the system. Turn the controller back on. The next time a call is received, Pump 1 will be the first to
power on.
See below for the location of the jumper pins.
Number of Devices
Pin Adjustment
B&D ROTATIONAL BOARD (BDCB-RC)
NOTES
Scranton, IA 51462
Phone (712) 652-3424
www.bdmfginc.com
13
To Next Page
Loading...