Why is there no sound on my B&K Reference 2220 ('on' LED not illuminated)?
If there is no sound and the 'on' LED is not illuminated, here are a few things to check: * Ensure the power cord is properly plugged in. * Verify that the AC power source is on, checking the AC switch or fuse. * Inspect the AC power inlet fuse for any shorts or overloading. * Confirm that the control switch is in the correct position.
What to do if there is no sound on some channels of my B&K Amplifier ('on' LED illuminated)?
If the 'on' LED is illuminated but there's no sound on some or all selected channels, try the following: * Tighten, repair, or replace any loose or faulty speaker leads. * Tighten, repair, or replace any loose or faulty line stage to amp cables. * Tighten, repair, or replace any loose or faulty source to line stage cables. * Check all switch settings to ensure the line stage or source is correctly selected.
What to do if my B&K Reference 2220 channel sounds distorted and low in output?
If a channel sounds distorted and has low output, the rail fuse inside the amplifier may have blown. Replace the blown rail fuse inside the amplifier.
Why does my B&K Reference 2220 sound lack direction and have weak bass?
If the sound lacks direction and the bass is weak, it could be that the speakers are connected out of phase. Check the connections to ensure that cables are connected (+) to (+) and (-) to (-).
Why is the output from my B&K Amplifier so low?
If the output from the amplifier is low, check the balanced switch position. If you are using unbalanced inputs, ensure the balanced switch is not in balanced mode. Put balanced switch in correct position.
How to fix loud hum or buzz on my B&K Reference 2220 Amplifier channels?
A loud hum or buzz on one or more channels may be due to a poor ground connection in the interconnect cables. Check all connectors and repair as necessary.
Key safety instructions regarding polarity, speaker ratings, ventilation, and placement.
Details the amplifier's electronic circuitry, high-quality parts, and power output stages.
Highlights the amplifier's Toroidal Transformers, Discrete Circuitry, and other notable components.
Details the AC fuse holder, including fuse type and replacement instructions.
Describes the AC power input connection for the amplifier.
Explains the connections for speakers to the amplifier.
Explains connections for balanced audio inputs.
Details unbalanced RCA input connectors for signal patching.
Describes the optional level controls for input adjustment.
Explains remote muting control via input/output connectors.
Describes the use of RCA connectors for unbalanced audio input.
Explains the use of XLR connectors for balanced audio input.
Provides recommendations for planning cable runs and component placement.
Lists common problems, their causes, and solutions for amplifier operation.
General| Input Sensitivity | 1.2 V |
|---|---|
| Input Impedance | 22k ohms |
| Dimensions | 17.5 x 19 x 7 inches |
| Weight | 15.9 kg |
| Type | Stereo Power Amplifier |
| Power Output | 200 watts per channel into 8 ohms (stereo) |
| THD | <0.1% at rated power |
| Signal-to-Noise Ratio | > 100 dB |
| Damping Factor | > 100 |
To Next Page
