To Next Page
K
Karen HansonJul 25, 2025
Why is there no sound on some channels of my B&K II ('on' LED illuminated)?
- CCheryl DoyleJul 25, 2025
If there's no sound on some or all channels of your B&K Amplifier while the 'on' LED is lit, the issue might stem from several causes: * Loose or faulty speaker leads: Ensure these are tightened, repaired, or replaced. * Loose or faulty line stage to amp cables: Tighten, repair, or replace them. * Loose or faulty source to line stage cables: Check and fix these cables. * Incorrect line stage or source selection: Verify all switch settings. * Blown speaker fuse: Inspect and replace if necessary. * Improperly adjusted level controls: Readjust the level controls.
General
