B&Q CSS1354 - Wardrobe Assembly Steps; Fitting of Drawer Runners; Fitting of Fixed Shelf; Fitting of Door Stops

1371mm
B
A
1371mm
B
A
Carefully fit 2 x part to the RH side panel, as shown. Then fit 3 x drawer
runners to the RH side panel, using screws (10mm), as shown.
Then fit 3 x hinge plates as shown (ensuring the arrow is pointing
towards the front edge of the panel). The hinge plates can be fitted to
either the LH side panel or the RH side panel, as required. In this example,
they have been fitted to the RH side panel.
Now repeat this process using the remaining part , and 3 x drawer
runners , for the LH side panel.
1
F551
Tight
against
panel
F139
Tight
against
panel
H
H
into hole 14
into
hole 17
P
P
P
1
Lower the shelf on to the
protruding Cam legs in the
Wardrobe side.
Gently ‘push’ down until the
panel ‘clicks’ into place.
Fitting of Drawer runners
H
into holes
20 and 21
into holes
35 and 36
into holes
52 and 53
AG
D
H
AG
H
2
Fitting of Fixed Shelf
3
Fitting of Door Stops
Now fit the doorstops , as shown.
Z
Z
Z
Using 2 people, turn
the unit around.
Now fix the back
to the fixed shelf as
shown.
RH side panel
AG
D
J
J J J
AE
J J J
into hole number 1
AG
into hole number 6
AG
into hole number 13
RH
side
panel
J
E
E
E
To fit the soft close mechanisms, place the template on top of the drawer runner with the end of the
template folded around the front face of the end panel, and mark the positions for the first two holes.
Carefully drill the first two holes using a 5mm drill bit, to a depth of 12mm, and then fix the soft
closer mechanism, using screws (12mm), so that it sits parallel with the drawer runner.
Finally, carefully drill the back hole, as before, and then secure.
Repeat this process for all 6 drawer runners.
D
P
P
CSS1354 02/10*