The GatewayPro has no serviceable parts inside the housing and no wiring chamber. During setup or standard operation,
there should not be a need to open the GatewayPro.
2.3 DX80 GatewayPro
The GatewayPro has many of the same features as the Gateway and Node, including the LEDs, the buttons, LCD, and
Euro-style connector.
1. Industrial ethernet port, female.
2. Rotary switch 1 (left). Sets the Network ID (NID) to a hexidecimal value
from 0 to F, for a total of 16 Network IDs. A Gateway and its
corresponding Nodes must be assigned the same Network ID.
3. Rotary switch 2 (right). On the Gateway, sets the Gateway’s LCD
viewing device address. The Gateway is predefined as Device Address 0.
On the Node, sets the Node’s Device Address (hexidecimal 1 to F). Each
Node within a network must have a unique Node Device Address.
3. Push button 1. Single-click to advance across all top-level DX80
menus. Single-click to move down interactive menus, once a top-level
menu is chosen.
4. Push button 2. Double-click to select a menu and to enter manual
scrolling mode. Double-click to move up one level at a time.
5. LED 1 and 2. Provide real-time feedback to the user regarding RF link
status, serial communications activity, and the error state.
6. LCD Display. Six-character display provides run mode user information
and shows enabled I/O point status. This display allows the user to
conduct a Site Survey (RSSI) and modify other DX80 configuration
parameters without the use of a PC or other external software interfaces.
On the Node, after 15 minutes of inactivity, the LCD goes blank. Press
any button to refresh the display.
7. 5-pin M12 Euro-style quick disconnect serial port.
2.4 DX83 Ethernet Bridge
The DX83 Ethernet Bridge uses the same housing and same mounting holes as the Gateway and Node.
1. Industrial ethernet port, female.
2. Housing. The rugged, industrial DX80 housing meets IEC IP67
standards.
3. Mounting hold, #10/M5 clearance. Mounting Holes accept metric
M5 or UNC/UNF #10 hardware -- DIN rail mount adapter bracket
available.
4. 5-Pin M12 Euro-style quick-disconnect serial port
Sure Cross
®
Performance DX80 Wireless I/O Networks
8 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
