Need help?Do you have a question about the Banner XS26-2e and is the answer not in the manual?
General| Brand | Banner |
|---|---|
| Model | XS26-2e |
| Category | Controller |
| Language | English |
Emphasizes user responsibility and compliance with instructions for safe operation and safeguarding.
Describes the input and output terminal capabilities for the SC10-2 safety controller.
Provides detailed electrical, mechanical, and safety specifications for XS/SC26-2 models.
Provides detailed electrical, mechanical, and safety specifications for SC10-2 models.
Step-by-step guide for installing the Banner Safety Controller software.
Discusses the role and monitoring of safety input devices for safety functions.
Explains safety circuit integrity levels and principles based on ISO 13849-1.
Details properties for configuring safety input devices, including reset logic.
Lists common safety input device circuits and their corresponding safety categories.
Explains the importance of safety circuit integrity levels per ISO 13849-1.
Covers requirements and considerations for monitoring E-stop push buttons.
Details requirements for using rope pull emergency stop switches.
Describes the function and application of enabling devices for machine control.
Explains the protective stop function for safeguarding purposes.
Covers requirements for installing interlocked guards and gates.
Discusses the use and requirements of optical sensors as safeguarding devices.
Details the requirements and application of two-hand control devices for machine operation.
Describes the safety outputs available on the XS/SC26-2 Base Controller.
Outlines the steps required to create and confirm a controller configuration.
Guides on designing the control logic by adding inputs, logic, and function blocks.
Covers the verification and saving process for controller configurations.
Enables real-time monitoring of Safety Controller status and fault information.
Allows testing of configurations in a simulated environment.
Outlines the schedule for system checkouts: initial, periodic, and daily.
Details the procedure for commissioning the Safety Controller and systems.
Steps to verify system operation and input/output functionality post-installation.
Covers procedures for initial setup, commissioning, and periodic checks.
Provides real-time operational data via the Software's Live Mode.
Provides real-time operational data via the onboard display.
Provides solutions for common issues encountered with the Safety Controller Software.
Lists and explains error codes encountered during block connections in the software.
Describes common faults detectable by the Safety Controller and their resolution.
A table listing fault codes for XS/SC26-2, their messages, and resolution steps.
A table listing fault codes for SC10-2, their messages, and resolution steps.
To Next Page
