9
3. INSTALLATION OF ACCESSORIES
Before the radio is ready for use we need to attach the battery pack, as well as charge the battery.
3.1 Installing/ Removing the Antenna
a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by holding the antenna at its
base and turning it clockwise until secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.
3.2 Installing the belt clip
a. To install the BELT CLIP, slide the clip down into the slot on the back of the radio until the BELT CLIP LATCH clicks.
b. To remove the BELT CLIP, press the LOCK TAB down, and then gently pull the belt clip up toward the top of the radio.
3.3 Installing the battery pack
Before attaching or removing the battery make sure your radio is turned off by turning the power/volume knob all the way
counter-clockwise.
To install the battery pack:
a. With the back of the radio facing you, insert the bottom part of the Li-ion battery pack to the bottom of the radio.
b. Push down the Li-ion battery pack into the radio until the Battery Lock Tab locks into place.
To remove the battery pack:
a. Press the Battery Lock Tab downward until the Li-ion battery pack unlocks from the radio.
b. Pull the Li-ion battery pack away from the radio.
3.4 Installing the Additional Speaker/Microphone (Optional)
Pry open the rubber MIC-Headset jack cover and then insert the Speaker / Microphone plug into the double jack.
To Next Page
Loading...
