that provides USBcharging power (NOTto a USBhub).
(2) Charge the batteries for 6 hours until the battery indicator either stops flashing.
2. Using the Charging Cradle
(1) Connect the included AC adapter with USBconnector cable to the charging cradle's Mini USBport. Connect the other end
to a standard AC wall outlet.
(2) Set the charging cradle on the desk or tabletop, and place the radio in the charging cradle with the keypad facing forward.
(3) Charge the batteries for 6 hours.
Note:
• Use only the supplied batteries, charger, and AC adapter or approved accessories.
• Charge time may vary depending on the battery life remaining.
• The batteries must be installed for the unit to operate, even if the unit is also connected to external power.
• If battery power is low, you cannot operate the radio even using external power. Allow the batteries to charge before using.
*If you try to transmit while power is low, the radio will automatically turn off.
Warning: Do not charge alkaline batteries. The radio will not be used for a long time, please take out and keep the
battery properly.
Operations
Power on/off and volume adjustment
Rotate the Power/Volume knob clockwise to turn the radio on. Rotate the control clockwise /counter-clockwise to adjust the
volume level as you prefer. To turn the radio off, rotate the control counter-clockwise till hearing a mechanical "click".
Transmission
To communicate, all radios in your group must be set to the same channel. Briefly press the Side key 1 to enable the Monitor
feature in order to make sure that the frequency is not busy, and then press the PTT key. Release the PTT key to receive. Only
4
To Next Page
Loading...
