Baofeng UV-5G PLUS - Page 32

32
6.9.2 Beep PROMPT (BEEP) - MENU 8
If you enable this function, every time a key is pressed, you will hear a Beep tone.
In standby mode, press
+ 8. The screen will display “BEEP PROMPT”.
Press
key to enter the function. Press the / keys to turn ON/OFF the beep function.
Press
key to confirm and exit to return to stand-by mode.
6.9.3 Voice function (VOICE) - MENU 17
In standby mode, press + 17; the screen will display “VOICE”.
Press
key to enter the function. Press the / keys to select OFF/ON. Confirm your selection by pressing MENU.
To return to the standby mode press
key.
6.9.4 Language of the MENU (LANGUAGE) - MENU 18
This section shows the language of the MENU (English).
In standby mode press
+ 18. The display will show “LANGUAGE”.
6.9.5 Working Mode (MDF-A) - MENU 24
The radio has four working modes available:
• Frequency mode (FREQ)
• Channel mode (CH)
• Channel name (NAME)
To shift from one mode to another one:
In Standby mode press
+ 24; select the desired working mode with the / keys.
Press
key again to confirm your selection.
6.9.6 Roger Beep, end Transmission Tone (ROGER) - MENU 36
Roger Beep can be enabled/disabled:
• OFF: Roger Beep disabled
• ON: Roger Beep tone at the end of transmission
In standby mode, press
+ 36; the screen will display “ROGER”.
Press
to enter the function. Press the / keys to select OFF/ON. Confirm your selection by press key.