Baofeng UV-5G PLUS - Page 37

37
16 CDCSS SAVE MODE ALL[0]RX[1]|TX[2]
Save the scanned CTCSS/DCS in VFO mode.
•ALL: Save to R-CDCSS and T-CDCSS
•TX: Save to T-CDCSS only
•RX: Save to R-CDCSS only
17
VOICE
- Voice Prompt
OFF [0] | ON [1] Allows audible voice confirmation of a key press
18
LANGUAGE
- Language selection
ENGLISH [0] | ᴬ㒆 [1]
Set the language type of menu and prompt
voice.
•ENGLISH: Display as an English menu with
English prompts for operation.
•Chinese: Display as a Chinese menu and
prompt for operation in Chinese.
19
DTMFST
- DTMFST
•OFF [0]: No DTMF Side Tones are heard
•DT-ST [1]: Side Tones are heard only from
manually keyed DTMF codes
•ANI-ST [2]: Side Tones are heard only from
automatically keyed DTMF codes
•DT+ANI [3]: All DTMF Side Tones are heard
Determines when DTMF Side Tones can be
heard from the transceiver speaker.
20
S-CODE
- Signal Code
1[0] | 2[1] | 3[2] | 4[3] | 5[4] | 6[5] | 7[6] |
8[9] | 9[8] | 10[9] | 11[10] | 12[11] | 13[12]
| 14[13] | 15[14]
Selects 1 of 15 DTMF codes. The DTMF codes are
programmed with software and are up to 5 digits
each.
21
SC-REV
- Scanner
Resume Method
•TO [0]: Time Operation - scanning will
resume after a fixed time has passed
•CO [1]: Carrier Operation - scanning will
resume after the signal disappears
•SE [2]: Search Operation - scanning will not
resume
Scanning Resume Method
22
PTT-ID
- When to send the
PTT-ID
•OFF [0]: No ID is sent
•BOT [1]: The selected S-CODE is sent at the
beginning
•EOT [2]: The selected S-CODE is sent at the
ending
•BOTH [3]: The selected S-CODE is sent at
When to Send PTT-ID Codes are sent during
either the beginning or ending of a transmission.