Baratza Sette 270Wi - CARE AND CLEANING; Removing Hopper and Burr Assembly

®
SETTE 270W i MANUAL
v2.1 May 11, 2018
9
CARE AND CLEANING
REMOVING THE BEAN HOPPER
Rotate the bean shutoff knob to the CLOSED position, then press the ‘’START’’ button to
purge any remaining beans. Remove the power plug from the power outlet. Remove the
hopper by rotating it counterclockwise until it stops, and then lift the bean hopper off of
the grinder housing. It can be helpful to remove/insert the hopper while the lid is on, to
provide stability.
REMOVING THE CONE BURR/GRIND ADJUSTMENT ASSEMBLY
1. The adjustable portalter hook must be swung to the side in order to remove the
grind adjustment assembly (g. C).
2. Rotate the bean shutoff knob so it is in the CLOSED position, then hold the START button to run any
remaining beans through the grinder (g. D).
3. Once the grinder has been fully purged, rotate the grind adjustment assembly beyond the coarsest setting
to the install/remove indicator (blue triangle). The assembly will release downward for removal (g. E).
g. C g. D g. E