R5912858 /05 AMM240ED10
2.1 Workspace
To prepare a suitable workspace
Before you carefully unpack your monitor, prepare a suitable workspace.
You need:
• a stable and level surface
• a grounded power outlet
• an area which is relatively free of glare from sunlight or other sources of bright light
The monitor is cooled by natural convection (it has no fan). For optimum performance, do not block the cooling
vents.
2.2 Unpacking
To unpack the monitor
• Inspect the monitor and other package contents for shipping damage that could cause a fire or shock
hazard.
• Immediately report any shipping damage to the carrier or transportation company and contact customer
service in case of return.
2.3 Cable connections
To connect the cables
1. Connect a supplied video cable (DVI-I, Y/C, BNC, BNCx4 to HD15) to the host system accordingly.
2. Connect the DC power to the DC power connector on the monitor.
3. Make sure that the AC power cord is the correct type required for the area.
4
4. Connect one end of the AC power cord to the AC-Adaptor.
5. Connect the other end of the AC power cord to a grounded power outlet.
6. Turn the host system on.
7. Turn the monitor on.
5
You can use a Bridgepower extension power cord (optional). The part numbers are: C-
47D2001P50MF (5 ft), C-47D2004P57MF (15 ft) and Z3404272 (75 ft).
To avoid damage to the unit or equipment, only connect the equipment to the HD/SD SDI optional
module.
Installation
4. For 120 V applications, use only the UL Listed detachable power cord with NEMA configuration 5-15P type (parallel blades) plug
cap. For 240 V applications use only the UL Listed detachable power cord with NEMA configuration 6-15P type (tandem blades) plug
cap.
5. If the monitor does not function properly, refer to the troubleshooting section to diagnose the problem.
To Next Page
Loading...
