2
Connecting to Clickshare Via Wireless
1. Set up your ClickShare as you normally would, connecting it to power, a monitor, and
connecting the antennas to the back of the unit. Turn the unit on.
2. After the unit has booted up, using a computer capable of connecting to a wireless
network in the 2.4GGHz and 5GHz channel bands, locate the ClickShare on your wireless
network and connect to it
3. You will be prompted to enter a password upon selecting the ClickShare network. If this
is the first time your computer has connected to a ClickShare unit, you will need to enter
the units SSID number (“ClickShare-(units serial number))” as the password (Example:
ClickShare-9714072768). If you have connected your computer to a ClickShare unit
previously, the password will be “clickshare”.
4. Still on your computer, open a web browser and navigate to the Clickshare units
“Wireless IP” address. If you are unsure what the wireless IP address is, it should be
displayed on the monitor you’ve connected the ClickShare to. By default, it is
192.168.2.1.
5. If this is the first time you have connected this unit to your computer, you will be
prompted to enter a user name and password. By default, both the user name and
password are “admin”.
6. You are now connected to your Clickshares web administration page.
To Next Page
Loading...
Need help?
General
