R5911438 /09 UDM26
9. Acclimatize and configure the used lens. Calibrate the lens and potential focus drift.
• To calibrate the mounted lens, use Projector Toolset or the Lens calibration menu in the GUI. For
detailed information, see the user guide of Projector toolset and the projector.
• To calibrate the focus drift, use the focus drift wizard in the Projector toolset. For detailed information,
see the user guide of Projector toolset and the projector.
10. Alignment of the projected image with the screen. Activate an internal test pattern to focus, zoom and shift
the lens until the projected image is aligned with the screen. Use for that the:
• Focus, Zoom and Shift buttons of the RCU.
• Lens adjustment button of the Local Keypad. For detailed instructions see user guide of the projector.
• Projector Toolset control software. For detailed instructions see user guide of Projector Toolset.
To level the projector with the screen adjust the feed of the projector in case of a table mount installation
(see “Alignment of a table mounted projector”, page 52), or adjust the rotation of the rigging frame in case
of a suspended installation (see “Alignment of projector in the rigging frame”, page 53).
11. If needed change the projector orientation (e.g. Front/Table, Front/Ceiling, Rear/Table, Rear Ceiling). See
user guide of the projector for the software settings of the projector orientation.
12. Check for the latest projector software package. See chapter “Software update”, page 58.
Installation process
To Next Page
Loading...
