Barco UDX Series - Page 5

Connect and select source
1. Connect available sources to the appropriate input ports.
2. Select connected source:
- Select LED (1) = GREEN -> Port configured as input. Image appears on the screen
- Select LED (1) = Blinking GREEN -> Bidirectional port configured as output/loopthrough
- Sync LED (2) = YELLOW -> sync/signal is present
Sync
Select
2
1
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SDI IN
SDI IN/OUT
SEL
SYNC SYNC
AB CD
SYNC SYNC SYNC
SYNC
DP HDBT 2
SYNC
HDMI HDBT 1
SYNC
3G/12G
3G
3G
3G
1
Quad SDI channel A: 3G/12G input
2
Quad SDI channel B: 3G input
3
Quad SDI channel C: 3G input or 3G/12G output
4
Quad SDI channel D: 3G input/output
5
DisplayPort 1.2 Input
6
HDMI 2.0 Input
7
HDBaseT Input 1
8
HDBaseT Input 2
1 2 3 4 5 6 7 8
Quad combo input card
SEL
SEL
SEL
SEL
DP A
DP B
DP C
DP D
SYNC
SYNC
SYNC
SYNC
3 4
1
Quad DisplayPort 1.2 channel A Input
2
Quad DisplayPort 1.2 channel B Input
3
Quad DisplayPort 1.2 channel C Input
4
Quad DisplayPort 1.2 channel D Input
1 2
Quad DP1.2 input card
Support
Website www.barco.com/esupport
- USA +1 866 374 7878
- EMEA +32 56 36 8019
- APAC +86 400 88 22726
Tel.: