Bard MEGA-TEC W090A - Jobsite Startup and Commissioning Report; HVAC Unit Installation - Verify the following:

7960-788
Revised: 2-13-17 Commissioning Report Page 1 of 3
Jobsite Startup and Commissioning Report
Shelter (Name/Number):
Commissioned By (Name):
Installation By (Company):
Installer Address/Phone No.:
Date Commissioned:
Shipping Inspection – Inspect each unit for the following:
Yes No Do any of the units have visible damage from falling over during transit?
Yes No Are any of the Condenser Coils located at the upper front of each unit Damaged?
Yes No Are any of the Condenser fan assemblies located in the top of each unit damaged?
Yes No
Inspect the lower front door and side panels of each unit. Are all door panels intact
and air/water tight?
Yes No
Inspect the blower wheel/housing by looking into the supply opening of each unit. Is
the blower wheel centered and able to spin inside the blower housing?
Yes No Inspect all accessories including supply and return louvers. Are they free of damage?
Model and Serial Numbers of HVAC units
Unit
Model Number
Serial Number
#1
#2
#3
#4
Model and Serial Number of Controller
Model Number
Serial Number
HVAC Unit Installation – Verify the following:
Yes No
Verify rain flashing is installed at the top of each unit. Has caulk or sealant been
applied per installation instructions to avoid water intrusion into each unit?
Yes No
Verify all high voltage wire routing requirements are met. Are all conduit connections
tightened and sealed for weatherization?
Yes No
Verify all communication wire routing requirements are met. Are all conduit
connections tightened and sealed for weatherization?
Yes No
Are all HVAC Unit outdoor service and airflow clearances on the sides, front, bottom,
and top met?
Yes No
A 24” minimum distance is needed between the supply and return openings and
equipment in the room. Are all HVAC Unit indoor supply and return clearances met?
Controller and Unit Communication Wiring – Verify the following: