28
MODEL SR124
28
ELECTRIC MAINTENANCE
• Disconnect battery ground cable before carrying out maintenance on electrics.
• The control panel lids should be closed at all times.
• A regular check of the control panel and all the connections is recommended.
• When maintenance or repairs are being carried out on the control panel, ensure it is covered to prevent any rain or water
getting in.
• Check daily for any damages, worn out parts and good operating switches.
• Only welders qualified to European Standards or similar are permitted to perform welding operations on the machine.
• Before working on the plant, switch off and isolate battery power.
• Again assess risk before working on the screener.
HYDRAULICS
• Only certified personnel should carry out any maintenance or servicing to the hydraulic system.
• Always relieve pressure from the hydraulic system before carrying out any kind of maintenance or servicing.
NEVER ATTEMPT TO ADJUST ANY HYDRAULICS WHEN THE MACHINE IS IN OPERATION
9) MAINTENANCE CONTINUED
To Next Page