Barko 595 ML - Start-Up Procedure

page 27page 27
page 27page 27
page 27
595ML CRL
800-00050
START-UP PROCEDURESTART-UP PROCEDURE
START-UP PROCEDURESTART-UP PROCEDURE
START-UP PROCEDURE
Fuel Level - proper level, any leaks?
Hydraulic Oil Level - proper level?
Hydraulic Reservoir Shut-Off Valves are Open? (Valves must be open before pumps are operated or
damage may occur to pump.)
Hydraulic Oil Leaks - check valves, fittings, cylinders, hoses, etc.
Engine Oil Level - proper level, any leaks?
Engine Air Cleaner - check for restriction, damage, etc.
Engine Compartment - clean, free of dirt, debris and flammable materials?
Radiator - any leaks, clean, proper fluid level?
Fan and Drive Belts - loose or worn belts?
Battery - be sure it is not disconnected - check for loose connections, damage.
Electrical System - frayed wires, loose connections, damage?
Cab and Platform - steps, floor, handrails, windows, controls clean and free of debris, dirt, grease, etc.
Guards and Shrouding - installed correctly, secure, clean?
Safety Warnings and Decals - clean, legible, and in proper place?(See Decal Locations)
Grease Fittings - lubricated? (see Service Schedule and Lubrication Points for daily maintenance)
Bolts/Nuts - check for wear or damage.
Gearboxes, Transmissions - any leaks, proper fluid levels? (See Service Schedule and Lubrication Points)
Loader Damage - clean, missing components, loose parts, cracks, vandalism, etc.
PRE-START MAINTENANCE CHECK LISTPRE-START MAINTENANCE CHECK LIST
PRE-START MAINTENANCE CHECK LISTPRE-START MAINTENANCE CHECK LIST
PRE-START MAINTENANCE CHECK LIST
See Start-Up Procedures on next page.
BEFORE STARTINGBEFORE STARTING
BEFORE STARTINGBEFORE STARTING
BEFORE STARTING
- Read the Safety Summary in section one of this manual before starting.
- Inspect machine before each shift or daily for items listed below in the Pre-Start Maintenance Check List.
- Know the machine's operating capabilities and limitations. Do not exceed them.
- Know and use the hand signals used in the work area and who has the responsibility for signaling.
- Position machine to allow good visibility of work area.
- Close cab door before starting machine.
- Activate controls by lowering the Servo Lever/Armrest.
- Adjust seat so that you can work comfortably. DO NOT adjust seat while engine is running.
- Fasten the seatbelt.