21
• Holds a program when pressed again—
HOLD light illuminates.
• Cancels hold and continues running
when pressed again—HOLD light is off
and RUN light illuminates.
• Exits a program when the button is held
down for two seconds—RUN and HOLD
lights are off.
• At the end of a program the RUN light
will flash.
• During holdback the HOLD light will flash.
PAGE button: allows you to choose a parameter
from a list of parameters.
SCROLL button: allows you to choose a param-
eter within a list of parameters.
UP button: allows you to increase the value in
the lower display.
DOWN button: allows you to decrease the value
in the lower display.
Controller Parameters
Home Display
°C: measured temperature in Celsius.
Temperature units can not be changed without
entering the configuration. Contact Customer
Service if a different temperature unit is required.
OP: % output power demand; displayed in lower
display (cannot be changed).
C.id: Controller identification number.
8 S
EGMENT & 4
X16 SEGMENT
PROGRAMMABLE MODELS W/OTP
To Next Page
Loading...
