SAFETY INFORMATION
SAFETY INFORMATION
3 4
The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or
any other enclosed area. The Table Top Grill may be stored indoor if the LP gas cylinder is removed and stored
outdoor. The LP gas cylinder (not included) is threaded for connection directly to the gas regulator supplied with
this appliance. Care should be taken when threading the cylinder to the regulator to engage threads correctly
to achieve the proper and intended connection. When disconnecting or connecting the gas cylinder, be careful
that the regulator does not strike the grill, the ground, or any other surfaces. Replace the protective cap over the
threaded cylinder connection when removed from grill. If any diculty occurs when connecting or disconnecting
the cylinder to the regulator assembly, contact your local gas supplier for assistance.
When re-connecting the LP gas cylinder to the regulator, be sure to hand-tighten until snug. This connection
should be inspected for damage and leak tested after each re-connection.
To leak test, make a soap solution of one part liquid detergent and one part water. You will need a spray bottle,
brush, or rag to apply the solution to the tting. Bubbles indicate leaks.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts
with package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
• Estimated Assembly Time: 10-15 minutes
• Tools Required for Assembly: Phillips Screwdriver and wrench (not included)
Note: The right and left sides of the grill are designated as if you are facing the front of the grill.
THE MARKING OF INJECTORS
The marking of injectors as diagram is the injector size.
REGULATOR AND HOSE ASSEMBLY:
After the assembly has been secured, turn on the gas and check for leaks. See the following Checking for gas
leaks,. Make certain this procedure is carried out in well-ventilated area and never in the presence of a ame,
spark or heat source.
· Never use a dented or rusty LP tank.
· Normally, it’s necessary to change the hose of regulator every 4 years.
To Next Page
Loading...
