12
TROUBLESHOOTING GUIDE
PROBLEM CAUSE REMEDY
The machine does not turn on Power cord is unplugged Plug Cord into 120V outlet
The fuse is blown Replace fuse
Insufficient water on brush Solution valve is closed Open valve
No water in solution tank Fill solution tank with water
Pump switch is off Turn the solution switch on
Blockage in solution tube Clean or replace the solution line
The pump is damaged Repair or replace pump
The machine does not clean well Brush drive switch is off Turn on brush drive
The brush is worn Replace brush
Drive belt is loose Adjust belt tension
The floor is not dry Vacuum switch is off Turn the vacuum switch on
Dirty squeegee blades Clean the squeegee blades
Dirty squeegee body Clean the squeegee body
Vac hose not attached to shoe Attach vac hose to the squeegee shoe
Squeegee blade is worn Replace squeegee blade
Too much foam is generated No defoamer in recovery tank Add defoamer to recovery tank
To Next Page
Loading...