What to do if basic coatings Dirt Dragon is not drying the floor?
If your Basic Coatings Floor Machine isn't drying the floor properly, make sure the vacuum switch is turned on. Also, check and clean the squeegee blades and body. Ensure the vacuum hose is properly attached to the squeegee shoe, and replace the squeegee blade if it's worn.
How to fix Basic Coatings Floor Machine that does not turn on?
If your Basic Coatings Floor Machine does not turn on, first ensure that the power cord is properly plugged into a 120V outlet. If it still doesn't turn on, the fuse might be blown, so try replacing it.
Why Basic Coatings Floor Machine does not clean well?
If the Basic Coatings Floor Machine isn't cleaning well, ensure the brush drive switch is on. If the cleaning is still poor, the brush may be worn and need replacement, or the drive belt might be loose, requiring tension adjustment.
What to do if basic coatings Dirt Dragon Floor Machine has insufficient water on brush?
If there's insufficient water on the brush of your Basic Coatings Floor Machine, first check that the solution valve is open and that there's water in the solution tank. Ensure the pump switch is on. If the problem persists, there might be a blockage in the solution tube, which you should clean or replace. In some cases, the pump may be damaged, requiring repair or replacement.
How to reduce foam in basic coatings Dirt Dragon Floor Machine?
If your Basic Coatings Floor Machine is generating too much foam, add defoamer to the recovery tank.
Explains the Dirt Dragon as an automatic scrubber for wood floors.
Identifies controls like ON/OFF switches, fuse holder, and power cord.
Identifies various machine parts like connections, valves, and gauges.
Steps to adjust the handle for comfortable operation or storage.
Details on filling tanks, adding detergent, and turning on switches.
Steps to turn off controls, raise brush deck, and empty tanks.
Steps to remove, rinse, and replace the recovery tank.
Instructions for cleaning the recovery tank lid and float cage.
Detailed steps for adjusting or replacing the belt tension.
Guide to increasing or decreasing brush head pressure.
Instructions for removing and replacing the squeegee blades.
Kit for hard surfaces including hose, wand, flip tool, and bag.
Kit for carpets/upholstery including hose, wand, carpet/upholstery tools.
Comprehensive kit with all available tool kit components.
Warranty for polyethylene tanks/housings and vacuum head assemblies.
Warranty for all other Basic Coatings components.
Warranty for tools, accessories, and the Dust Dragon Bac Pac Vac.
General| Type | Floor Machine |
|---|---|
| Power Source | Electric |
| Voltage | 120V |
| Pad Size | 12 inches |
| Cord Length | 50 feet |
To Next Page