Installation Guide
Basler IP Camera 9
LanguageLanguageLanguageLanguageLanguageLanguageLanguageLanguage
We recommend that connections to the input and the output be made with
shielded cable and that the cable shields be connected to ground. If you are
unable to connect the cable shields to ground or if you use unshielded cable,
we recommend that you install a ferrite bead on each cable near to the camera
to minimize electromagnetic interference.
5 RS-232
Transmit
RS-232 transmit.
Note: RS-232 transmit on the camera should be connected to
RS-232 receive on your device.
6 RS-232
Receive
RS-232 receive.
Note: RS-232 receive on the camera should be connected to
RS-232 transmit on your device.
Pin Function Description
Table 2: Camera Pinout
To Next Page
Loading...
Need help?
General
