14 P1512120 R3
2.15. Tire Safety
Failure to follow proper procedures when mounting a tire on a
wheel or rim can produce an explosion that may result in
serious injury or death.
• DO NOT attempt to mount a tire unless you have the proper
equipment and experience to do the job.
• Have a qualified tire dealer or repair service perform
required tire maintenance.
• When replacing worn tires, make sure they meet the original
tire specifications. Never undersize the replacement tire.
• DO NOT weld to the tire rim with the tire mounted on the
rim. This action may cause an explosion which could result in
serious injury or death.
• Inflate tires to the manufacturer’s recommended pressure.
• Tires should not be operated at speeds higher than their
rated speed.
• Keep wheel lug nuts tightened to manufacturer’s
recommendations.
• Never reinflate a tire that has been run flat or seriously
under-inflated without removing the tire from the wheel.
Have the tire and wheel closely inspected for damage before
remounting.
2.16. Battery Safety
• Wear safety glasses and protective gloves when working near
batteries.
• Make certain the battery or terminal covers are in place and
in good working order.
• Keep all sparks and flames away from batteries; gas given off
by electrolyte is explosive.
• Avoid contact with battery electrolyte. Wash off any spilled
electrolyte immediately.
• Do not tip batteries more than 45° to avoid electrolyte loss.
• To avoid injury from sparks or short circuits, disconnect
battery ground cable before servicing any part of an electrical
system.
2. SAFETY PORTABLE GRAIN BELT CONVEYOR – S-DRIVE FIELD LOADER
To Next Page
Loading...